For the workers engaged in the stone processing industry, in order to protect the safety of the foot, they can wear safety shoes correctly when they work, which can greatly reduce personal injury and improve work efficiency. The following small series explains the specific work that needs to be done in a dangerous place:
Plate lame
Some varieties of plates are more likely to break when transported (or loaded), such as Yalunjin, Dark Brown, Bodu Beige, Clove Beige, etc., when the broken stones fall to the feet, most will make the feet Injury, the impact it produces even fractures the foot.
Nail
Due to the large amount of nails used in the process of nailing large plates and finished packaging, if the management is not good, it is easy to have broken nails or nailed wood boards scattered workshops causing foot accidents; if there are many water ditches in the workshop, if the water ditches are not covered, When the nail falls into it, it becomes a hidden danger that is hard to find.
slip
Due to the wet operation, the stone workshop floor often has water, which lasts for a long time, and some corners grow mossy; or the floor is covered with self-produced smooth marble floor; the machine leaks oil; or it is not cleaned up after the glue is cleaned up. Residual glue on the ground.
Falling from a height
For fitter repairs or electric welders, customers picking up materials or selecting materials, and hoisting workers picking blocks or lanyards often require climbing. In most cases, it is difficult to use protective equipment such as seat belts, making the operation more dangerous.
electric shock
Some employees and even low-level electrical safety awareness is weak, and the bare wire is directly connected to electricity; the operating staff drags the wires entangled on the ground, or allows the vehicles to be pressed, causing damage to the wires. Caused an electric shock. Such hidden dangers are common at the grinding job site.
Foot protection
Experience has shown that wearing appropriate safety shoes can effectively reduce the risk of injury to the foot injury or reduce the degree of damage. The wear-resistant safety shoes can be used as an example to reduce the incidence of accidents by half and save large losses. Therefore, in the following work environment, the operator should configure the corresponding safety shoes:
1 Engaged in operations that may have falling objects (such as lifting, upper board, maintenance work, etc.), it is necessary to wear steel toe caps and safety shoes that can withstand falling impact or extrusion to protect the toes;
2 There are dangers of sharp objects in the environment, such as nails, blades, sharp stones, etc. In order to prevent them from piercing the shoes, puncture-proof safety shoes or boots should be used;
3 For the special profession of electricians, special types of conductive or insulated shoes and boots must be used when working on AC equipment with AC 1500V and below at 50Hz, 1000V and below;
4 Workshop machine operators, due to the water stains and muddy mud on the work site, wearing high-steel steel toe cap rubber safety boots with anti-slip and anti-smashing has a good protection.
Properly wearing the appropriate safety shoes for the above dangerous scenes is not only a requirement for good work safety protection, but also to do your own labor protection from the actual situation!