The shoe size of safety shoes is generally half a yard to one yard longer than the average shoe size. Because the front of the safety shoes needs to be equipped with a protective steel toe cap, so be careful not to buy too small when choosing safety shoes.
Safety shoes are different from the size of ordinary casual shoes. In the selection, you need to measure the size of your feet. There are two ways to measure: Physical measurement method: The correct posture must be taken when measuring: 1. Stand with legs in parallel ( Do not sit, 蹲); 2. Weight is equally divided on the feet. Then take the measurement, put the foot flat on a piece of white paper, press hard on the ground, use the pen to point out the widest point on the left and right, and then use the front and rear points to point out the longest point before and after. Finally, 2 points before and after and 2 points left and right are connected to the correct length and width of the foot. (Note: both feet must be measured, and take the maximum value) Calculation formula method Safety shoe shoe code calculation formula: (shoe size +10) X0.5 = (the theory is longer) cm Example: such as 42 yards of shoes. (42+10) X0.5=26 cm.
The shoe codes circulating in the market are rather messy. The more reliable method is to try to wear suitable safety shoes. Try to wear comfort, the toe cap of the toe does not produce squeezing and kicking on the foot, the toe can move flexibly, there is no feeling of sliding forward or backward, and the heel of the shoe does not feel off the shoes when walking. The so-called fit, mainly refers to: the size of the shoe is consistent with the foot, not too big or too small; the toe can move freely in the shoe; the waist support of the shoe firmly fits the arch; the heel of the shoe is stable.
Even if you choose a safety shoe by trying on it, the basics of its choice cannot be neglected. There are mainly the following aspects:
1. The front tip of the safety shoe has a certain margin, especially the safety shoes, because the front has a hard steel head. When wearing it, pay attention to the toe cap with sufficient margin. Usually, if you stand for a long time, then the toes should have more room for movement. Otherwise, the toes will be in a state of being squeezed for a long time. After a long time, the feet will cause great damage! Many people choose safety shoes when they choose safety shoes. They are bigger than the usual fashion shoes. This is because safety shoes are increased according to national requirements when they are made. In fact, we usually wear large size shoes. Just buy a size of safety shoes.
2, the variety of safety shoes, the requirements for fat and thin are also different. The fatness of the foot is expressed by the width of the sole of the foot and the circumference of the toe. The fatness of the shoe is determined by the size of the inner space of the shoe cavity. It depends on the length of the toe and the width of the bottom of the shoe. The manufacturer chooses the decision. Consumers can only choose according to the try-on effect.
3, the heel of the safety shoes and the heel are not tight and just coincide.
4, the safety upper can not squeeze the instep.
5, the waist of the safety shoes and the arch of the foot, the waist must hold the foot.